quote:I had the same EXACT
problem and have been pulling out my hair for a month.
Here's the solution:
-Goto the D-linkrouter configuration site (198.168.0.1)
-Click on the Advanced tab at the top, then click the Performance
button on the left
-Change the Preamble setting to long
-Wait for router to restart, close programs, and try to get on the
internet.
This was posted for various Apple forums. Hope this helps.
I too signed up for this forum just to say THANKS!
WOW!!! I was pulling my hair out too! I had just added a software for Home
Network Setup (Network Magic) and it worked fine for a day. THEN! all of a
sudden, Neither of my wireles connection could renew the I/P. It showed
that I was connected, but no I/P.
I would like to thank you very much for your information/help!!!!!!
hob10
Newbie
Posts: 1 Registered: 27/5/08 Status: Offline
posted on 27/5/08 at 18:10
quote:I had the same EXACT
problem and have been pulling out my hair for a month.
Here's the solution:
-Goto the D-linkrouter configuration site (198.168.0.1)
-Click on the Advanced tab at the top, then click the Performance
button on the left
-Change the Preamble setting to long
-Wait for router to restart, close programs, and try to get on the
internet.
This was posted for various Apple forums. Hope this helps.
How can I go to the D-link router configuration site (198.168.0.1) if I
cannot get the D-link connected properly? I tried plugging the Ethernet
into the LAN port and that gives me connectivity, but I cannot access the
198.168.0.1 site.
