I have a Parkervision WR1500 and I am very happy with it. It installed and
worked fine from the start.
My problem is with changing the name of the network on the router. The
default is Wireless . I would like to change it to home .
Under System > General is System Name: . The default is
empty. What is this?
Under Wireless is ESSID . Value = Wireless. Is this the name of
the network? If I change this value to home , and delete the Profile00
from the PV Config utility, then have PV Config create a new profile, I
cannot connect.
In other words, I can connect easily with the defaults. But when I change
the ESSID, I can not connect.
How can I rename my local network?
Thank you
StuartB
Newbie
Posts: 1 Registered: 5/3/08 Status: Offline
posted on 5/3/08 at 08:41
Hi heibeck.
I know it's been a while since you posted but I thought I'd try and contact
you to see if you could help.
Just wondered if you still have the Parkervision WR1500 Router.
If so I need to know the output voltage and current from the power adapter
in to the router.
I can't remember if it's printed on the adapter, but I can't find out from
anywhere at the minute.
It's probably something like 12volts @ 1 or 2 Amps or similar.
I lost / misplaced my adapter and can't remember the voltage / current
rating of it.
I have emailed Parkervision but they not replying.
I would really appreciate it if you could help.
Thanks in anticipation,
StuartB
dael
Newbie
Posts: 1 Registered: 6/8/08 Status: Offline
posted on 6/8/08 at 23:58
it is 12vdc + is center pin @ 1.2 amps output, 250maamps in
