Subject: Problems adding Wavit11 to existing NetGear Access Point
rptut
Newbie
Posts: 1 Registered: 16/9/03 Status: Offline
posted on 16/9/03 at 15:07
Any insight or help would be greatly appreciated.
I have been running a wireless connection off my
existing LAN successfully for several months now,
using a Netgear WG602 Access Point and a Netgear
card in my laptop. This past weekend I tried
adding a Wavit11 to the mix, but I can't seem
to get it to connect. (I eventually want to use
the Wavit11 as a station for my Replay) I’m
using one of the other computers to try to set
up the Wavit11, this is what I have found…
The Wavit11 Identifies the WG602 Access Point (shows
it on a status list, but labels it disconnect
) after I match the SSID, enter in the correct
channel and encryption, but the WG602 doesn't show
the Wavit11 on its station list.
The WG602 is working properly with the wireless
laptop card (also Netgear). I’ve tried having
encryption on and off and I have tried using the
WG602 in both 802.11b and 802.11b/g modes (the
Wavit11 is only 802.11b)
The Wavit11 is set in infrastructure mode
because I want it to act as a station. I
tried switching the Wavit11 to Access Point
and the laptop was able to connect with it, so
I know it is working.
It seems as if all my wireless components can
recognize each other, except the WG602 Access point
can not see the Wavit11 station. Any suggestions on
what I might do?
